Haltech Installs
Nissan Skyline | Package includes a E11V2 & patch loom to suit, 3 bar map sensor, air temp sensor, installation & set-up of ecu, installation of wiring & sensors, and full dyno tune.Total cost $3710.00 | |
Nissan Silvia | Package includes a E8 & patch loom to suit, 3 bar map sensor, air temp sensor, installation & set-up of ecu, installation of wiring & sensors, and full dyno tuneTotal cost $3230.00 | |
Mitsubishi EVO | Package includes a E8 & patch loom to suit (check EVO model first), 3 bar map sensor, installation of ecu, installation of wiring & sensors, and full dyno tune (on 2 wheels only)Total cost $3230.00 | |
Toyota Supra | Package includes a E11V2 ecu & ecu & patch loom to suit, 3 bar map sensor, air temp sensor, installation of ecu, installation of wiring & sensors, and full dyno tuneTotal cost $3810.00 | |
Holden VN - VP (+some VR, 6 cyl or V8) | Package includes a E6GMX ecu, 2 or 3 bar map sensor as required, Air temp sensor as required, installation of ecu, installation of wiring & sensors, and full dyno tune. Note that this ecu can be used for n/a, turbo or supercharged applications, and will plug straight in to the standard 2 connector ecu wiring used on the "early models"Total cost $2630.00 |
 |  |  |
Haltech's external mount interceptor, or internal mount miniceptor (or piggyback if you prefer) can be wired into many vehicles to control the fuel & ignition parameters, eg:
Mazda MX5- Mitsubishi Magna
- Toyota Hilux 2000 - 2005
- Toyota MR2
- Toyota Corolla
- Holden LS1 5.7 & the LS2 6.0 versions
- Ford EL, AU 5.0 Windsor
These interceptors will not control auto trans functions, and installation/tuning prices vary depending on application. Contact us & discuss your individual requirements.
Holden VL RB30E & ET, R31 Skyline, EVO 1, 2 & 3 | The E6X with it's internal 2.5 bar map sensor can be used with a patch loom on these vehicles. Hardware for the application will vary, but the basic cost to supply, install & tune would start at:$2675.00 |
WRX to 2005 can be tuned using the E11V2 with patch loom. The ECU alone costs $2275. Installation with sensorsshould be similar to other E11V2 vehicles. An AWD dyno is required to tune these vehicles, which AAD does not posess.
Haltech accessories available:
1,2 or 3 bar map sensors- Air temp sensor
- Coolant temp sensor
- Boost control solenoid
- Throttle position switch
- Idle speed motor (air bypass)
- Idle motor housing
- Shift light
- Trim module (fuel, boost, ignition etc adjustments)
